Avago Technologies eXtremeRAID 2000 - Manual (Page 24)

Connectors, Jumpers, and LEDs
2-2 eXtremeRAID 2000 Installation Guide
Connectors, Jumpers, and LEDs
Up to four Ultra 160 SCSI channels are supported on the controller. Figure
2-1 shows SCSI connector locations.
All the jumpers should normally be set to their default settings. Table 2-1
contains default jumper settings. Figure 2-1 shows jumper locations.
The controller has 19 LEDs which are active indicators while the controller
is running. The LEDs indicate termination type and status, SCSI activity,
cache status, diagnostic status, and host activity. Figure 2-1 shows LED
locations and meanings.
Figure 2-1. eXtremeRAID 2000 Controller with Jumpers, LEDs and Connectors