Elmo ESD-CC1 - Manual (Page 15)

4.2.8.7 Set TILT bias
4.2.8.8 Check Camera Version
This item shows you the hardware and software version of the dome camera, it may be an useful information when you’re
checking with the installer for trouble shooting.
4.2.8.9 Auto Save Function.
The user can disable or specify the duration time of 1~42 minutes to make a power-up default preset point for dome
camera to go back after the operator stops moving the dome.
4.2.8.10 Line Lock Phase Adjust Function.
User should not use this function for detailed adjustment of camera module.
4.2.8.11 Receiver Auxiliary Switch Function.
Users can press 1 or 2 to select one of two receiver auxiliary switches and then press "◄" / "►" key to turn on/off receiver
auxiliary switch.
4.3 System Setting Mode
If you press the “SYS” key and enter the correct password (default password is 0000), the keyboard will enter ‘System
Setting Mode’. Detail description of each item will be discussed in the following sections. Please use "▲" and "▼" keys to
scroll through these setup pages.
2.8 Camera Version
H/W:Vx.x S/W:Vx.x
Fig.4.2.8.8
2.7 Set TILT bias
[+1]
Fig.4.2.8.7
2.9 Auto Save Func.
01 Min.
Fig. 4.2.8.9
2.10 Llock Phase Adj.
Press ◄► to - / +
Fig. 4.2.8.10
2.11 Receiver AUX
Press 1/2 to setup
Fig. 4.2.8.11
2.11 Receiver AUX1
ON [OFF]
Fig. 4.2.8.12
15