Elmo ESD-CC1 - Manual (Page 10)

A. The first three digit (xxx) indicate the step number.
B. PST means ‘Preset Point’, it is the preset point used for this step, range from 1 to 128.
C. SPD means ‘Speed’, it defines how fast the dome will move from previous step to this step, the number range from
1 to 15.
D. DWELL means the dwell time of this step. The number range from 1 to 127, and the unit is second.
If you want to insert a step in the sequence, you can press “INS” key, then key in the parameters in current position. If you
want to delete a step in the sequence, just press “DEL” key, current step will be erased immediately.
After sequence editing is finished, you may use “ESC” or "ENDSEQ" keys to exit. The difference between these two keys
is: pressing “ENDSEQ” will delete the steps behind current step; pressing “ESC” will keep every step effective.
4.2.5 Auto-Pan
Under Camera Control Mode, you can press “AUTOPAN” key to enter Auto Pan mode, the LCD will display:
Auto Pan mode:
Press "1", the dome start to pan automatically, and the LCD will display:
Press "2" allows you to edit the route of auto-pan. You have to move the dome to the start point, and press “Enter” key to
confirm.
Then move the dome to the end point and press “Enter” key to confirm.
xxx. PST SPD DWELL
[001] [10] [000]
Fig.4.2.4.2
3.0 AutoPan select:
1. Run 2. Setting
Fig.4.2.5.1
xxx P/T/Z/F/OSD Cam
Running AutoPan…
Fig.4.2.5.2
3.1 AutoPan Setting
Enter for Start Pos.
Fig.4.2.5.3
10