Figure 2-1. configuration controls, 3 rear terminations on the mst 488-27, Rear terminations on the mst 488-27 -5 – KEPCO MST 488 Programmer User Manual

Page 23: Configuration controls -5, E 2-1)

MST 488-27 013004

2-5

FIGURE 2-1. CONFIGURATION CONTROLS

2.3

REAR TERMINATIONS ON THE MST 488-27 (SEE FIGURE 2-2)

a. AC INPUT. The MST 488-27 draws power from the same source used to power the MST

power modules. Power is applied through the Rack Adapter via the AC/control bus connec-
tor.

b. IEEE 488 BUS. This port is a 24 pin IEEE 488 connector and conforms mechanically and

electrically to the IEEE 488 standard. Refer to Table 2-4 for pin assignments.

c. RS 232-C PORT. This port is a standard 9 pin RS 232-C (male) connector). Refer to Table

2-4 for pin assignments and PAR. 2.2.1.4 for additional information.