TA Triumph-Adler DCC 2930 - Manual (Page 115)

Basic Operation
3-21
3
Punch
Punch holes in sets of finished copies in preparation for binding.
NOTE: Requires the optional document finisher and punching unit.
For details on paper sizes that can be punched, refer to Hole Punch Unit (Option) on page Appendix-30.
The orientations of the original and corresponding punch positions are as follows.
NOTE: The inch model provides two-hole and three-hole punching. The metric model provides two-hole and
four-hole punching.
Original Copy
Document
processor Platen
Orientation of Original