TA Triumph-Adler 261ci - Manual (Page 169)

9-9
Fax Settings > Default fax settings
TX/RX Restriction
This function allows you to send or receive originals only when communication requirements are met.
For details, refer to Transmission Restriction on page 9-10.
Forward Settings
When you have received a fax, you can forward the received image to other faxes and computers or specify a number of
copies.
For details, refer to Memory Forwarding on page 6-2.
Adjustment/Maintenance
Adjust printing quality and conduct machine maintenance.
Service Setting
ECM RX Set whether ECM RX is performed.
ECM is a communication mode specified by the ITU-T (International Telecommunication Union)
that retransmits data when an error occurs. Fax machines that have ECM mode check for
errors as they communicate, preventing distortion of the image due to noise on the line and
other conditions.
Value : On, Off
NOTE
When there is a large amount of noise on the line, communication may take slightly
longer than when [Off] is selected.
RX Start Speed Change the RX Start Speed.
When communication conditions are bad, the fax may not be received correctly. In that case,
set a lower RX Start Speed.
Value : 9600bps, 14400bps, 33600bps
NOTE
Normally this should be used with the default setting.
Item Description
FAX Call Settings (Europe
only) When using this machine in environment in which PBX for connection to multiple phones for
business use is installed, perform the following PBX setting.
Exchange Selection If the machine is connected to a PBX, set [PBX].
Value : PBX, PSTN
Dial No. to PSTN Set a number to access an outside line. For the number, contact the PBX administrator.
Value : 0-9, 00-99
Item Description