TA Triumph-Adler CX 8020 - Manual (Page 76)

4. 1. 1. 7 Code “J6” : Mis-feed of cut sheet paper (Incorrect size)
Mis-feed Code “J6” is indicated when you set a cut sheet
STAND BY
SL
LIGHTER DARKER
FILM
VELLUM/TRACING
PLAIN PAPER
MEDIA
ROLL
CUT SHEET
C
CLEAR DECREASE INCREASE
LEAD EDGE
TRAIL EDGE
CUT MODE
DECREASE INCREASE
C
CLEAR
STOP
ALL CLEAR
paper of incorrect size.
(Incorrect size means shorter than 279mm or longer than
3 meters.)
Rear Front
Remove the mis-fed original in the following direction.
1. Open the Upper Unit (1).
Chapter 4 Error Treatment 4-17
1