TA Triumph-Adler CX 8020 - Manual (Page 33)

6. Strip off the tape (6) which fixes the film (8), and then put the Holder (9) on the right end of the
Toner Cartridge as the following picture.
6 8 9 8
NOTE
Do not discard the tape (6) at this point of time because it will be used later.
7. Insert the Spool (10) to the holes of Holder (9),
while catching the film (8) between its pins.
Then rotate the Spool (10) clockwise to wind up
the film.
8. Fix the film roll (8) with the tape (6).
Rotate the Spool (10) a few revolutions counter-
clockwise, pull it out from the film roll, and then
discard the film roll.
Chapter 2 Basic Operation 2-11
8
10
8
6
10
9