Ipsec (ipsec setting), Ipp over ssl (ssl server ipp over ssl setting), Https (ssl server https setting) – TA Triumph-Adler P-C3570DN User Manual
Page 176

Using the Operation Panel
4-103
IPP over SSL (SSL Server IPP over SSL setting)
IPP over SSL is an encryption function that uses SSL for communications
between users and servers in network printing. To use IPP over SSL, both
server and client must support the protocol. The default setting is Off.
1
In the SSL Setting menu, press or to select IPP over SSL.
2
Press [OK]. The IPP over SSL screen appears.
3
Press or to select whether IPP over SSL is enabled.
4
Press [OK]. The IPP over SSL setting is set and the SSL Setting
menu reappears.
HTTPS (SSL Server HTTPS setting)
HTTPS (HyperText Transfer Protocol Secure) is a protocol that adds SSL
data encryption, message authentication and a digital signature function
to the HTTP protocol used for data transfer between WWW servers and
clients.
S-HTTP is a similar protocol, but HTTPS differs in that it uses SSL. The
default setting is On.
1
In the SSL Setting menu, press or to select HTTPS.
2
Press [OK]. The HTTPS screen appears.
3
Press or to select whether HTTPS is enabled.
4
Press [OK]. The HTTPS setting is set and the SSL Setting menu
reappears.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
The default setting is On.
1
In the Network Security menu, press or to select IPSec.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
IPP over SSL:
a
b
1 *Off
2 On
HTTPS:
a
b
1 Off
2 *On