RIGOL DG1000 Series - Manual (Page 23)

RIGOL
Quick Guide for DG1000
15
Utility System
Press
to enter utility system setting interface.
Figure 16 Utility system setting interface
Table 4 Parameters of utility system
Parameters Explanations
Sync On
Sync Off
Enable/disable the Sync Signal of CH1 through
the [Sync Out] connector on the rear panel.
CH1 Basic setting of CH1
CH2 Basic setting of CH2
Coupling Coupling settings of dual channels
Count
Turn on the counter to observe the
measurement results and set corresponding
parameters.
System
Set the language, screen display, beeper, screen
saver, format and system configuration.
I/O View USB Information
Test/Cal
Do self-test and calibration operation or view the
instrument information.
PA Setup power amplifier.