RIGOL DG1000 Series - Manual (Page 17)

RIGOL
Quick Guide for DG1000
9
Setting methods of other waveforms are the same as the
example above. All the parameters permitted to be set are
listed in the following table.
Table 1 Parameters of basic/arbitrary waveforms
Waveforms Parameters
Sine
Frequency/Period, Amplitude/High Level,
Offset/Low Level, Phase
Square
Frequency/Period, Amplitude/High Level,
Offset/Low Level, Duty Cycle, Phase
Ramp
Frequency/Period, Amplitude/High Level,
Offset/Low Level, Symmetry, Phase
Pulse
Frequency/Period, Amplitude/High Level,
Offset/Low Level, Width/Duty Cycle, Delay
Noise Amplitude/High Level, Offset/Low Level,
Arbitrary
Frequency/Period, Amplitude/High Level,
Offset/Low Level, Phase
2． Modulated Waveform Settings
CH1 of DG1000 can generate AM, FM, FSK and PM waveforms.
Press
 Type to select the modulation type from
“AM/FM/FSK/PM” and enter the setting interface.
E.g. Press
 TypeAM to enter the AM setting interface:
Figure 8 AM setting interface under menu display