RIGOL DG1000 Series - Manual (Page 19)

RIGOL
Quick Guide for DG1000
11
Press to enter sweep waveform setting interface as
follows. Thereinto, parameters as Linear/log, Start/Center,
Stop/Span, Time and Trigger are allowed to be set.
Figure 10 Sweep waveform setting interface
4． Burst Waveform Settings
Various burst waveforms can be generated by CH1 of DG1000
in burst mode.
Press
to enter the setting interface. Parameters as
Cycles/Infinite, Phase, Period, Delay and Trigger are allowed to
be set in N-Cycle mode; while Polarity and Phase are available
in Gated mode.
Figure 11 Burst waveform setting interface