RIGOL DG1000 Series - Manual (Page 21)

RIGOL
Quick Guide for DG1000
13
Output Setting
The two yellow buttons located at the right of front panel shown as
follows are for controlling the channels output and counter input:
Figure 14 Channel /Counter Connector
Channels output
 Connect the connector shown above with an external device by
BNC cable.
 Press the corresponding “Output” button to start channel
outputting. Meanwhile, the backlight of “Output” button turns
on and a “ON” sign appears in user interface. To turn off the
channel output, press “Output” again.
Counter Input
The counter enables to measure frequency (100mHz~200MHz),
period, duty cycle and positive/negative pulse width of a input
signal.
 Press
 Count to enter the counter mode, meanwhile,
the “Output” button of CH2 is turned off and channel output is
closed automatically.
 Connect the generator with external device by BNC cable, so as
to input external signal into the counter.
CH2 Output/Counter
Input Connector
CH1 Output Connector