Usb connection, Bnc connection – RIGOL DG1000 Series User Manual
Page 14
RIGOL
Quick Guide for DG1000
6
USB Connection
USB Host:
This port is used to transfer data when external USB device
connects to the generator regarded as a “Host” device. For example,
connect a USB flash device for data storage.
USB Device:
This port is used to transfer data when external USB device
connects to the generator regarded as a “Slave” device. For
example, connect with PC for remote control.
BNC Connection
Connectors need to be connected by BNC Cable include: “CH2/
Counter” connector (refer to Figure 14) at the front panel, “10MHz
In”, “Sync Out”, “Modulation In” and “Ext Trig/FSK/Burst” at the rear
panel. Insert BNC cable to the conector vertically and rotate the BNC
connector clockwise to lock it.
Figure 4 BNC interfaces on the rear panel