RIGOL DS6000 Series - Manual (Page 41)

RIGOL
RP1001C User’s Guide 11
Certifications and Compliances
EC Declaration
of Conformity
– Low Voltage
Low Voltage Directive 73/23/EEC, as amended by
93/68/EEC
Low Voltage Directive 73/23/EEC, as amended by
93/68/EEC
EN 61010-1/A2:1995: Safety requirements for electrical
equipment for measurement, control and laboratory use
- Part 1: General requirements .
EN 61010-2-032:1995: Safety requirements for electrical
equipment for measurement, control and laboratory use
- Part 2-032: Particular requirements for hand-held
current clamps for electrical measurement and test.
Additional
Compliance
IEC61010-1/A2:1995: Safety requirements for electrical
equipment for measurement, control and laboratory use
- Part 1: General requirements
.
IEC61010-2-032:1994: Safety requirements for electrical
equipment for measurement, control, and laboratory use
- Part 2-032: Particular requirements for hand-held
current clamps for electrical measurement and test.
Installation
(Overvoltage)
Category
CAT III: Equipment in a fixed industrial location (usually
permanently connected)
CAT II: Equipment at this level includes appliances,
portable tools, and similar products. Equipment is
usually cord-connected.
CAT I: Secondary (signal level) or battery operated
circuits of electronic equipment.
Pollution
Degree
A measure of the contaminates that could occur in the
environment around and within a product. Products
should be used only in the environment for which they
are rated.
Pollution Degree 1:
No pollution or only dry, nonconductive pollution occurs.
Products in this category are generally encapsulated,
hermetically sealed, or located in clean rooms.
Pollution Degree 2:
Normally only dry, nonconductive pollution occurs.
Occasionally a temporary conductivity that is caused by
condensation must be expected. This location is a typical
office/home environment. Temporary condensation
occurs only when the product is out of service.