RIGOL DS6000 Series - Manual (Page 32)

RIGOL
2 RP1001C User’s Guide
Control/Indicator Description
Current flow symbol: The arrow shows
the positive direction of current flow.
Zero adjustment: After connecting to
power and fixing the current probe to a fixed
position, rotate the knob to adjust the probe
output to the proper DC offset. It may also
be used to offset a DC signal component.
Zeroing is not needed for AC measurements
unless your instrument cannot isolate a DC
component (if present).
Range switch: Slide the switch from OFF to
either the 10 mV/A or 100mV/A range. When
10 mV/A or 100mV/A is selected, the probe
is turned on, and the green battery indicator
(ON) lights.
Battery indicator: The green
battery/power indicator lights when the
probe is turned on. For more information,
please refer to To Install the Battery.
Overload indicator: The red overload
indicator lights and flicks continuously if the
measured signal is greater than the
maximum range of the selected range
capacity.