Switching on the flowfinder, Start up in validate mode will look like this – Retrotec Flow Finder MK 2 User Manual

Page 9

Text mode
Original mode

Page 9 of 17

M:\PDF\Source\Manual-FlowFinder mk2\Manual-FlowFinder mk2.docx

5. Switching on the FlowFinder

Press the On/off push button is on the lower left hand side of the
panel to start the FlowFinder. It will start up in one of two measuring
modes: “Validate” and “Adjust”. See Section 6.3 to choose.

Start up in Validate Mode will look like this:

The display will show “- - -” and the parameters will be as shown below.

Time and date

Pressure difference to

be compensated

Status battery pack

Temperature

Humidity

Measured flow in

m3/hr, l/s or CFM,

here m3/h

USB connected?

(only for service)

Horizontal bar graph

(0 to 1000 m3/h) of

the measured flow

SD card present? green!

not present? red..

Ready to measure in “Validate” mode