RISCO Group ProSYS Version 8.xx - Manual (Page 7)

ProSYS Version 8.xx - Supplementary Instructions 7
BUS Zone Parameters: iWISE DT Grade 2
Quick Keys Parameter Default Range
[2][0][3][zz]
[6][2] Local (automatic)
Once an hour, the detector automatically checks that the detector’s channels
are functioning properly.
BUS Zone Parameters: iWISE DT Grade 3
Quick Keys Parameter Default Range
[2][0][3][zz][1] LEDS On
Defines the LEDS operation mode.
[2][0][3][zz][1]
[1] to [2] LEDS Options
1) Off - Disables the LEDS operation.
2) On – Enables the LEDS operation.
[2][0][3][zz][2] MW (Microwave) Range Trimmer
Defines the microwave channel range.
[2][0][3][zz][2]
[1] to [7] MW Range Options
1) Minimum 2) 25% 3) 50% 4) 65% 5) 85% 6) Maximum 7) Trimmer (MW is
defined by the trimmer setting on the PCB)
[2][0][3][zz][3] ACT No
Defines the Anti-Cloak™ Technology (ACT) operation mode.
[2][0][3][zz][3]
[1] to [2] ACT Options
1) No - Disables the ACT mode.
2) Yes – Enables the ACT mode.
[2][0][3][zz][4] Automatic Microwave Omit No
Defines whether the MW channel will be omitted or not while the detector
identifies a fault in the MW channel.
[2][0][3][zz][4]
[1] to [2] Automatic Microwave Bypass Options
1) No - While detecting a problem in the MW channel it is not omitted. Alarm
condition cannot be established until the MW channel is fixed.
2) Yes - Switches the detector to operate only in PIR mode in case of MW
fault.
[2][0][3][zz][5] Green Line No
A feature that follows environmental guidelines by avoiding surplus emission.
This feature defines the activation of the microwave channel while the system
is disarmed.
[2][0][3][zz][5]
[1] to [2] Green Line Options
1) No - Green Line feature is disabled. MW is constantly activated.
2) Yes – Green Line feature is enabled.
[2][0][3][zz][6] Anti-Mask Enable
Defines the operation of Anti Masking detection.