RISCO Group ProSYS Version 8.xx - Manual (Page 10)

10 ProSYS Version 8.xx - Supplementary Instructions
BUS Zone Parameters: iWISE QUAD Grade 3
Quick Keys Parameter Default Range
[2][0][3][zz][5]
[1] Remote (manual)
The remote self test is performed by the system when a user manually
selects the Diagnostics option from the Maintenance menu via the ProSYS
User Functions menu.
[2][0][3][zz][5]
[2] Local (automatic)
Once an hour, the detector automatically checks that the detector’s channels
are functioning properly.
BUS Detector Naming Conventions
The following table contains the names of the various BUS detectors and their corresponding
Engineer programming menu codes under the Type field, when adding a new BUS zone to the
system.
BUS Detector TYPE Field Option
in Previous Versions TYPE Field Option
in Version 7 and above
WatchOUT DT ODT15 ODT15
WatchOUT PIR OPR12 OPR12
Industrial LuNAR LUNR Cannot be selected,
Replaced by Industrial
LuNAR Grade 3.
Industrial LuNAR Grade 3 LUNG3 ILun3
WatchIN IDT25 WatIN
iWISE DT G2 BUS 15m, 25m N/A iDTG2
iWISE QUAD G2 BUS N/A IQUG2
iWISE DT G3 BUS 15m, 25m N/A iDTG3
iWISE QUAD G3 BUS N/A IQUG3
New Firmware Capabilities
The information in this section describes new capabilities in the ProSYS firmware and new
parameters under the Engineer programming menu.
WatchOUT Proximity Anti Mask
WatchOUT DT version B (P/N RK325DT00UKB) has a new proximity anti masking capability in
addition to its regular IR anti masking capability.
When the WatchOUT DT is installed as a BUS zone, in order to enable Proximity Anti-Mask the
following parameters must be programmed: