RISCO Group WL S52 - Manual (Page 7)

Wireless Sounder Instructions 7
Step 2: Setting the Sounder Parameters
Each sounder can be defined with different sets of parameters. The following table
describes the list of parameters of the sounder.
NOTE:
For the specific programming location of each parameter refer to the system manuals.
Strobe Control
Defines the Strobe operation mode:
¾ Always Off: The strobe is deactivated
¾ Follow Bell (Default): The strobe is activated when the sounder bell is
triggered
¾ Follow Alarm: The strobe is activated when an alarm event occurs in the
system
Strobe Blink
Defines the number of times the strobe will flash per minute (Default 40 times per
minute). Strobe Blink options:
[1] 20 times per minute [4] 50 times per minute
[2] 30 times per minute [5] 60 times per minute
[3] 40 times per minute (Default)
Strobe Arm Squawk
The time that strobe blinking will continue when set is performed (Default: 05)
NOTE:
If the sounder’s squawk strobe is defined as NO (Refer to the Allocation section) this parameter will be
ignored.
Adjusting the Volume
Defines the sounder sound volume for the following system modes:
¾ Exit / Entry: The sound produced during Exit/Entry time (Default: 0)
¾ Alarm: The sound produced during alarm (Default: 9)
¾ Squawk: The sound produced during squawk sounds (Default: 9)
The sound volume range is between 0 (silent) to 5 (maximum volume).
Muting Tamper
This feature disables a tamper alarm from the sounder and it is recommended to be
used when replacing the sounder's batteries.
NOTES:
1. An ongoing tamper alarm will not be disabled.
2. WisDom: This feature is controlled under the Engineer Menu (Quick key [9][2][5]). Tamper alarm
will be disabled during the current installation programming period.
3. Agility: This feature is controlled under the Grand Master menu. Tamper alarm will be disabled for
20 minutes.