RISCO Group WL S52 - Manual (Page 4)

Wireless Sounder Instructions 4
Mounting the Sounder
To mount the sounder follow this procedure:
Step 1:
Remove the Cover Screw Assembly. The screw cover is opened by asserting
thumb pressure on it and pushing outward to reveal the cover screw.
Unscrew the cover screw and hinge the lid open to approximately 45 degrees, lift
the cover away until the tongue of the hinge engages. Squeeze the two halves of
the tongue together and remove the cover.
See figure 1:
Figure 1
Step 2:
Once the cover has been removed it may be placed in the Cover Holder Clip. This
is done by placing the cover hinge into the second hinge slot just inboard of the
outer hinge slot.
See figure 2:
Figure 2
Step 3:
Using the base plate as a drilling template, mark the drill holes on the wall. Drill the
holes and insert the wall plugs.
Step 4:
Fix the sounder to the wall.
Step 5:
Access to the PCB is gained by releasing the inner cover retaining the clip and
lifting the cover upward until it locks into the raised position.
See figure 3: