RISCO Group WL RWS401 - Manual (Page 8)

Wireless Sounder Instructions
8
Pre Alarm indication
This wireless sounder incorporates a pre-alarm feature that enhances the security of
the system by producing a local alarm in case of sabotage.
If defined, the system sends a pre-alarm signal to the sounder at the beginning of the
entry delay. If the sounder does not receive a cancellation signal from the system at
the end of the entry time, the sounder goes into alarm mode.
NOTE:
WisDom (Ver 4.25): Engineer menu Quick key: 1)System> 2)Parameters> 35)Sounder Pre alarm
Agility: Engineer menu: [1][2] > Advanced > Sounder Pre alarm
LightSYS (V2.40 and above): Engineer menu 1) System > 2) Controls > 7) Device > 5) Sounder Pre
alarm
Step 3: Testing the Sounder
Communication Test
The sounder communication test performs a communication test between the sounder
receiver and the system.
To perform a communication test:
1. Access the communication test option.
NOTE:
WisDom: Engineer menu > 9) Devices > 2) Sounders > 3) Communication test
Agility: Engineer menu > 2) Testing > 5) Sounder > 1) Communication test
LightSYS (V2.40 and above): Installer Code/User menu: Maintenance > Wireless Test >Wireless
Sounders > Comm. Test.
2. The system sends a test signal to the sounders. A number between 00-99 indicates
the strength of the communication signal between the system and the sounder.
NOTE:
For successful communication, the strength of the signal should be higher that the sounder receiver
noise threshold level.
WisDom: Engineer menu quick key [9][2][4], Agility: Engineer menu > 2)Testing >1) Main unit >
1)Calibration).
Agility: Engineer menu: 2) Testing > 1) Main unit > 1) Calibration
LightSYS (V2.40 and above): Engineer menu: 7) Install > 2) WL Device > 1) RX Calibration.
Diagnostics
The Diagnostics menu enables to test parameters reflecting the operation of the
sounder:
Speaker batteries voltage: Tests the selected sounder’s speaker batteries voltage
Radio batteries voltage: Tests the selected sounder’s radio's batteries voltage
Sounder version: Displays information regarding the sounder's version
NOTE:
WisDom: User menu: 4) Maintenance > 7) Sounders > 1) Diagnostics
Agility: Engineer menu > 2) Testing> 5) Sounder>2) Battery test > 3)Version
LightSYS (V2.40 and above) Battery Test: Installer Code/User menu: Maintenance > WL Test > WL
Sounders > Battery test
LightSYS V2.40 and above) Sounder Version: Installer Code/User menu: Maintenance. >
Diagnostics > Sounders > Select Sounder >Version
The diagnostic features can also be performed from the Upload/Download software, locally or
remotely.
Sounder Calibration: Displays information regarding the noise level around the
sounder.