RISCO Group WL RWS401 User Manual

Page 4

Wireless Sounder Instructions

Mounting the Sounder

To mount the sounder follow this procedure:

1. Open the front cover by removing the case locking screw located at the bottom of

the unit.

2. Hold the mounting pattern template (supplied) against the wall and mark the

locations for the mounting holes (4 mounting holes are available).

Drill the desired

mounting holes and place the screw anchors.

3. Mount the back unit to the wall using the supplied screws, 3.9mm, 32mm length

screws (DIN 7981 3.9X32 ZP).

4. Insert a tamper screw into a tamper hole -- see the figure below.
5. Access to the PCB is gained by releasing the inner cover retaining the clip and

lifting the cover upward (rotating it on its axis).

6. Insert the supplied batteries in the metal clips according to the polarity. The

sounder is ready for communication set up with the system.

Tamper Screw

7. After the sounder is trained, Close the inner cover, re-attach the front cover and

lock the Cover Screw Assembly.