HP OfficeJet Pro 7740 - Manual (Page 114)

CAUTION: Network settings are provided for your convenience. However, unless you are an advanced user,
you should not change some of these settings (such as the link speed, IP settings, default gateway, and
firewall settings).
To print network settings
Do one of the following:
● From the printer control panel, touch or swipe down the tab at the top of the screen to open the
Dashboard. Touch
(Wireless) or (Ethernet) to display the network status screen. Touch Print
Details to print the network configuration page.
● From the printer control panel, touch or swipe down the tab at the top of the screen to open the
Dashboard, touch
( Setup ), touch Reports , and then touch Network Configuration Page.
To set the link speed
You can change the speed at which data is transmitted over the network. The default is Automatic.
1. From the printer control panel, touch or swipe down the tab at the top of the screen to open the
Dashboard, touch ( Setup ), and then touch Network Setup.
2. Touch Ethernet Settings.
3. Select Advanced Settings.
4. Touch Link Speed.
5. Touch the appropriate option that matches your network hardware.
To change IP settings
The default IP setting for the IP settings is Automatic, which sets the IP settings automatically. If you are an
advanced user and want to use different settings (such as the IP address, subnet mask, or the default
gateway), you can change them manually.
TIP: Before setting a manual IP address, it is recommended to first connect the printer to the network using
Automatic mode. This allows the router to configure the printer with other needed settings like subnet mask,
default gateway and DNS address.
CAUTION: Be careful when manually assigning an IP address. If you enter an invalid IP address during the
installation, your network components cannot connect with the printer.
1. From the printer control panel, touch or swipe down the tab at the top of the screen to open the
Dashboard, touch ( Setup ), and then touch Network Setup.
2. Touch Ethernet Settings or Wireless Settings.
3. Touch Advanced Settings.
4. Touch IP Settings.
A message appears warning that changing the IP address removes the printer from the network. Touch
OK to continue.
5. To change the settings manually, touch Manual (Static), and then enter the appropriate information for
the following settings:
●
IP Address
● Subnet Mask
ENWW Change network settings 101