Precision Digital PD941 - Manual (Page 23)

ConsoliDator Multi-Channel Controller Instruction Manual
23
Backlight
Selecting [YES] under Save BL automatically turns the backlight off if no buttons are
pressed for five minutes. This is recommended unless it is necessary to have the
backlight constantly on. When [NO] is selected the backlight is always on.
Baud Rate
Select any available baud rate.
Parity
Select [EVEN – 8E1] for Even parity, 1 stop bit.
Select [NONE – 8N2] for None parity, 2 stop bits.
Select [NONE – 8N1] for None parity, 1 stop bit.
Modbus ID
Specify an address for Modbus communication.
Tx Delay
Specify a serial data transmission delay (response.)
Place cursor at the channel you want to set and press ENTER.