Precision Digital PD6060 - Manual (Page 8)

Model PD6060 Dual-Input Process Meter Instruction Manual
8
SPECIFICATIONS
Except where noted all specifications apply to operation at +25°C.
General
DISPLAY
Main (big) display: 0.60" (15 mm) high, red LEDs
Second (little) display: 0.46" (12 mm) high, red LEDs
6 digits each (-99999 to 999999), with lead zero blanking
DISPLAY
INTENSITY
Eight user selectable intensity levels
DISPLAY
UPDATE RATE
5/second (200 ms)
OVERRANGE Display flashes 999999
UNDERRANGE Display flashes -99999
DISPLAY
ASSIGNMENT
The main (Big) and second (Little) displays may be
assigned to process values for Channels A (Ch-A), B (Ch-
B), or C (Ch-C), toggle between (Ch-A & Ch-B, Ch-A & Ch-
C, Ch-B & Ch-C, and Ch-A, Ch-B, & Ch-C), toggle between
Channel & units, show channel gross value (no tare) or
toggle net (tare) and gross values, show relay set points,
max & min values, or Modbus input. The second display
may also be set to show engineering units or be off, with no
display.
PROGRAMMING
METHODS
Four front panel buttons, digital inputs, PC and MeterView Pro
software, Modbus registers, or cloning using Copy function.
NOISE FILTER
Programmable from 2 to 199 (0 will disable filter)
FILTER BYPASS
Programmable from 0.1 to 99.9% of calibrated span
RECALIBRATION
All ranges are calibrated at the factory. Recalibration is
recommended at least every 12 months.
MAX/MIN
DISPLAY
Max/min readings reached by the process are stored until
reset by the user or until power to the meter is turned off.
PASSWORD
Three programmable passwords restrict modification of
programmed settings.
Pass 1: Allows use of function keys and digital inputs
Pass 2: Allows use of function keys, digital inputs and editing set/reset points
Pass 3: Restricts all programming, function keys, and digital inputs.
NON-VOLATILE
MEMORY
All programmed settings are stored in non-volatile memory
for a minimum of ten years if power is lost.
POWER
OPTIONS
85-265 VAC 50/60 Hz, 90-265 VDC, 20 W max
or jumper selectable 12/24 VDC
± 10%, 15 W max