Electrolux FOM 71 CLS - Manual (Page 63)

16:1
Adjustment of temperature, speed and water
FOM 71 MP-Lab
Adjustment of temperature, speed and water
In contrary to Wascator FOM 71 CLS, there is little scope to change or
calibrate the internal parameters of the FOM 71 MP-Lab software.
Temperature:
• If the temperature of a wash program is too high or too low during the
main wash sequence, the temperature sensor must be replaced.
Speed:
• If speed is too low (wash speed and/or spin speed), check incoming
voltage and frequency.
• If speed is too high (wash speed and/or spin speed) check incoming
voltage and frequency. Also check to see whether the V-belt is exhibit-
ing signs of excessive wear. Changing to a new V-belt will/may reduce
the speed somewhat.
Water:
• For level adjustment, see Chapter 13.
• For flow meter adjustment, see Chapter 17.