MCZ Vivo 80 Pellet Comfort Air - 2012 - Manual (Page 19)

A
A
C
B
17
3-INSTALLATION AND ASSEMBLY
Technical Dept. - All rights reserved - Reproduction is prohibited
PREPARATION AND UNPACKING
The product is supplied in a single package. The pipe, feeding door and ventilation grille are packaged inside. A box is placed on top of the
package with the Comfort Air Slim or Basic Kit inside.
Open the package, remove the product from the pallet and set it in the pre-selected place, making sure this complies with the requirements.
The two brackets must be removed in order to remove the product from pallet, by loosening the two flanged nuts and the two screws.
The appliance must always remain in a vertical position and handled solely with a cart. Pay particular attention to the door and its glass,
protecting them from mechanical knocks that would compromise their integrity.
In any case, the product must always be handled with care. If possible, unpack the product near the place of installation. The packaging
materials are neither toxic nor harmful, and therefore no particular disposal measures are required. Therefore, the end user is responsible
for product storage, disposal or possible recycling in compliance with the relative applicable laws.
If the product must be connected to an exhaust pipe that goes through the rear wall (to enter the flue), make sure not to force it in.
PACKAGING: VIVO 80 PELLET
COMFORT AIR
A - SCREW
B - NUT
C - BRACKET