MCZ Vivo 80 Pellet Comfort Air - 2012 - Manual (Page 13)

11
2-INSTALLATION INSTRUCTIONS
Technical Dept. - All rights reserved - Reproduction is prohibited
FANS ELECTRICAL CONNECTION
The kit comes with 2.5 metre long silicone cables for fans cabling. Start cabling as follows:
In position 2 connect the yellow/green wire while in position 1 connect the remaining two wires (the colour sequence does not matter as
the fans do not have polarization) (fig.7).
The terminal block, to which one must connect the fan cables (fig.8), is screwed to the upper part of the structure .
Connect the two fans earthing cables to the first clamp on the left (T). Connect the remaining two cables from the LH fan with the clamps
connected to the white cables (B). Connect the remaining two cables from the RH fan with the clamps connected to the purple cables (V).
IMPORTANT!
The fan connection cable is made of silicone to resist high temperatures. In the event of extension cables (over 2.5 m)
and in any case under all circumstances, make sure that the cable does not come into contact with hot parts of the
unit, or with air connecting pipes within the cladding or structure.
FIGURE 7– FANS CLAMPS POSITION FIGURE 8– CABLES POSITION ON TERMINAL BLOCK