Epson 60 User Manual
Page 46
Allocate the required memory proportion to
the S channel. The value can only be from 0
to 9. Press
or
until the setting is correct.
Then press
.
Do the same for the P channel.
Ignore the O channel. Just press
.
Then either:
❐ Press
to cancel the new setting.
Then go back to step 3 or press
twice to
return to printer "Ready" mode.
❐ Press
to store the new setting.
The machine resets itself and returns to
printer "Ready" mode.
CH TIMEOUT (Channel Timeout)
This allows you to set the time for a channel timeout. If the printer is on line and re -
ceives no new data for the number of seconds specified, and if there is data in the
other channel, the printer will automatically switch to the other channel. The factory set -
ting is 60 seconds.
Available Options: 10 to 600 seconds (in steps of 10).
1. Enter Level 2 mode (see page 34).
2. Press
or
until CH TIMEOUT is displayed.
3. To change the current setting:
4. Press
or
until the required setting is dis -
played.
5. Store the displayed setting:
6.
twice to return to printer "Ready" mode.
ADJUSTING THE PRINTER SETTINGS
40