Epson 60 User Manual

Page 32

SELECTYPE LEVEL 1 FEATURES

How to Enter Selectype Level 1

The procedure for entering Level 1 is as follows.

If you have set your printer up in Autosense Multi-user mode: The changes that
you make to the Level 1 settings will only be valid for the channel that is displayed on
the screen to the right of READY just before you enter Selectype mode.

1. Make sure that the printer is in printer "Ready" mode.

Note: If the machine is in fax standby mode, press

Function 3 5 Yes

2. Press

until the display is as shown on the

right. Then release the key immediately.

Note:

If you press the

key for too long, you will enter Level 2 mode.

If so, press

until you get to standby mode, then try again.

If you have set the printer up in
Individual Multi-user mode: The display on
the right will now appear.
Either:

❐

Press

to select the serial channel. Go to step 3.

❐

Press

to select the parallel channel. Go to step 3.

❐

Press

to leave Level 1.

3. The display soon changes to show one of the

Level 1 menu features. An example is shown
on the right.

4. Press

until the feature that you want

is displayed.

If you change a Level 1 setting and want to keep it permanently (that is, if you do
not want the machine to go back to the old setting when you switch the power off),
save your current settings as a macro with the SAVE MACRO routine (see page
31), then make that macro the power-on macro with the POWERON MACRO
routine (page 33).

Each of the Level 1 features is explained in the following pages. For a concise list of
the features that are available in level 1, see page 21.

ADJUSTING THE PRINTER SETTINGS