Enterasys Networks SNS-TAG-LPA - Manual (Page 31)

Changing Trusted Access Gateway Settings
SNS-TAG-HPA / SNS-TAG-LPA Installation Guide 3-3
You are now ready to use Trusted Access Manager to manage your Trusted Access Gateway
appliance. If this is your initial commissioning of the appliance, you can launch Trusted Access
Manager and select Getting Started from the Trusted Access Manager Help pull‐down menu for
information on using Trusted Access Manager to configure and manage your TAG appliance.
If you are upgrading your Trusted Access Gateway software, be sure to enforce the TAG appliance
(via Trusted Access Manager) following the upgrade operation. Enforcing writes your Trusted
Access Manager Security Domain information to the appliance.
Changing Trusted Access Gateway Settings
Use these steps if you need to change your TAG appliance settings following your initial appliance
configuration.
Changing Basic Network Configuration
To change basic network configuration settings such as hostname and appliance IP address, enter
the following command at the appliance CLI:
/opt/tag/dnetconfig
This will start the network configuration script and allow you to make the required changes. You
must reboot the appliance for the new settings to take effect.
Changing the Management Server IP Address
To change the IP address of the management server, enter the following command at the appliance
CLI:
/opt/tag/configMgmtIP
Then, start using the new management server by typing:
tagctl restart
Enabling the SNMP Daemon
To enable the SNMP daemon, enter the following command at the appliance CLI:
/usr/postinstall/snmpconfig
Follow the configuration instructions.
Then, start the SNMP daemon by entering:
/etc/rc.d/rc.net-snmp restart
If you reboot the appliance, the SNMP daemon will start automatically.
Changing SNMP Passwords
To change SNMP passwords, enter the following commands at the appliance CLI:
vi/etc/snmp/snmpd.conf
/etc/rc.d/rc.net-snmp restart