Extron Electronics SCP 150 - Manual (Page 3)

i SCP 150 • Table of Contents
Chapter 1 • Introduction .......................................................... 1-1
About the SCP 150, SCP 150 AAP, and SCP 150 L . 1-2
Features ...................................................................................... 1-2
Chapter 2 • Installation and Operation .......................... 2-1
Installation Overview ......................................................... 2-2
Installing or Replacing Button Labels ......................... 2-2
Mounting Options .................................................................. 2-3
UL Requirements .................................................................... 2-4
Preparing the Site ................................................................. 2-4
Installing the Electrical Box ............................................. 2-5
Cabling the Rear Panel ....................................................... 2-6
Pre-installation Testing/Troubleshooting .................. 2-8
Mounting the SCP .................................................................. 2-8
Mounting in a wall box .......................................................... 2-8
Mounting in a rack ................................................................. 2-9
Mounting on a lectern ........................................................... 2-9
Front Panel Features .......................................................... 2-10
Resetting to Factory Firmware Version ................... 2-13
Chapter 3 • Remote Communication ............................... 3-1
Setting Up RS-232 Communication .............................. 3-2
Using Simple Instruction Set (SIS) Commands ....... 3-2
Host-to-SCP communications ................................................ 3-3
SCP-initiated messages ........................................................... 3-3
Error responses ........................................................................ 3-3
Using the command/response tables .................................... 3-3
Symbol definitions ................................................................. 3-4
Special Function SIS Commands .................................... 3-7
Using the Switch/Function Button Table ............... 3-10
Switch number locations ...................................................... 3-11
Updating the Firmware .................................................... 3-12
Appendix A • Specifications , Part Numbers,
Accessories, and Dimensions ............................................... A-1
Specifications ......................................................................... A-2
Included Parts ......................................................................... A-3
Table of Contents