Melinera Z31805A-BS/Z31805B-BS/Z31805D-BS - Manual (Page 5)

5 GB/IE/CY
Ensure that there are no items in the water that
could be sucked into the pump. The product
may otherwise be damaged.
Only use the indoor fountain with distilled water
with out any additives such as fragrances or the
like. Additives which are mixed in can ignite.
This may result in injury and / or damage.
Avoid the danger of death from
electric shock!
Before use, ensure the available mains voltage
matches the voltage required for mains adapter
6 (230–240 V∼, 50 Hz).
Always check the device, the pump 4 and the
mains adapter for any damage before connec-
ting it to the mains.
A damaged device represents the danger of
death from electric shock.
Never open any of the components of the
electrical equipment or insert any objects into
the same components. This will pose a risk of
fatal injury from electric shock.
Never touch the mains adapter with moist or
wet hands.
Ensure that the mains adapter never comes into
contact with water or other liquids.
Do not use the power cable for purposes for
which it was not intended e.g. for carrying the
pump, hanging it up or to pull the mains adapter
out the plug. Keep the lead away from heat,
oil, sharp edges or moving equipment parts.
Damaged or tangled leads increase the risk of
an electric shock.
Dispose of the electrical parts of the product if
the cable is damaged or if you find any kind of
mechanical problems. The electrical parts of
the indoor fountain and all associated devices
cannot be replaced.
Only carry out work on the device if the mains
adapter is disconnected from the mains.
Never leave the pump running without water.
Before first use
Carefully unpack the product and accessories.
Note: Be careful not to inadvertently throw
away any assembly materials whilst unpacking.
Place the water container 8 on an even and
level surface near a power socket (230–240 V∼,
50 Hz).
Ensure that there are no objects near the area
which could get damaged by water spray
whilst the fountain is in use.
Start up / use
Q Installation
Fill the water container 8 up to the marking
MAX (inside wall) with distilled water.
Put the supply hose 3 of the pump 4 in the
supply nozzle.
Move the pumps +/- slider 7 into the middle
position.
Put the decorative attachment with the base
plate 10 and the attached pump into the water
container and lead the mains power lead 5
through the notch on the back of the base plate.
For model Z31805A-BS / Z31805B-BS
(fig. A / B):
Push the LED 9 over the hose 1 to the con-
nection between the hose and the decorative
attachment
11 . The LEDs must face in the
direction of the decorative attachments.
For model Z31805C-BS / Z31805D-BS
(fig C /
D):
Push the LED over the supply hose 2 to the
connection between the supply hose and the
decorative attachment. The LEDs must face in
the direction of the decorative attachments.
Note: For model Z31805D-BS:
Place the glass ball 12 on the water jet open-
ing of the decorative attachment (fig. D) and
set the pump to „Max.“.
Your indoor fountain is now ready for use.
102742_mel_LED-Zimmerbrunnen_Content_BS_IE_CY.indd 5 21.07.14 08:53