Melinera Z30094C-BS - Manual (Page 40)

40 GB/MT
Preparing for use / Use
Preparing for use / Use
Assembly
Note: Have a vessel filled with approx. 800 ml water ready before
you start assembly.
Unpack the product and the accessories carefully.
Note: When you are unpacking the components make sure that
you do not unintentionally throw away any of the assembly materials.
Place the water container 12 on a flat and even supporting sur-
face near a mains socket (230–240 V~, 50 Hz).
Mount the lamp attachment assembly 1 on to the ornamental
stone 2 . To do this, position the lamp attachment 4 exactly
over the holes for the lamp attachment 3 and fix it firmly in
place by screwing in the screws 5 (see Figure A). Use a PH1
screwdriver to tighten the screws.
Fill the water container 12 with water up to the MAX marking
(inside wall) of the water container 12 .
Increase (MAX) or reduce (MIN) the flow of water issuing from
the ornamental stone 2 by means the + / - slider 14 (Fig. C).
Place the base 6 with the attached pump 8 on the water
container 12 and guide the lead from the pump 8 through the
recess 16 .
Decorate the base 6 with the pebbles 13 .
Your tabletop fountain is now ready for use.
Switching the tabletop fountain on and off
Insert the adapter 11 into a properly installed mains socket to
switch the tabletop fountain on. The lamp halogen bulb 18 illumi-
nates and water flows out of the ornamental stone 2 .