beautypg.com

Maintenance and cleaning – Florabest FSG 85 B1 User Manual

Page 13

background image

13

GB

2. Use a flat file to file down the height of

the depth limiter lug (28) and, after re-

setting, round off the depth limiter lug

a little. The original shape must remain

intact.

Maintenance and

cleaning

Disconnect the plug before adjust-

ment, maintenance or repair.

Have any work not described

in these instructions carried

out by a specialist workshop.

Use only original components.

Allow the equipment to cool

before carrying out any main-

tenance and cleaning work.

There is a risk of burns.

Before each use, check the equipment for

obvious defects such as loose, worn or dam-

aged components and check that screws or

other parts are sitting correctly. In particular,

check the grinding disk ( 18). Replace

damaged parts.

Cleaning

Do not use cleaning agents or sol-

vents. Chemical substances may

attack plastic parts of the equipment.

Never clean the equipment under

running water.

• Clean the equipment thoroughly after

each use.

Clean the ventilation openings ( 21)

and the surface of the equipment with

a brush or cloth.

• Clean the guide rail (

 

7) with a brush.

• In case of heavy dirt, loosen the lock-

ing screw for the chain clamping unit

(  10) and remove the chain clamp-

ing unit and rotary disk (  12) for

better access.

We recommended removing the side

plates for cleaning.

Changing the grinding disk

Instructions for changing:

• Never operate the equipment with-

out the protective screen (  20).

• Ensure that the rotation speed

specified on the grinding disk

(  18) is equal to or greater

than the idle-running speed of the

equipment.

Ensure that the disk dimensions fit

the equipment.

• Use only fault-free grinding disks

(ring test).

• If the locator hole in a grinding

disk is too small, do not subse-

quently redrill in order to increase

the size.

• Do not use separated reduction

bushes or adapters in order to

make a grinding disk fit where the

hole is too large.

• Do not use saw blades.

• Reassemble the equipment fully

after changing the grinding disk.

Switch off the equipment and dis-

connect from the mains.

Allow the equipment to cool.

1. Unscrew the grinding disk cover

(3).

2. Remove the grinding disk nut

(18b) by hand.

3. Take the grinding disk (18a) off

the adapter.

4. Place a new grinding disk on the

adapter and tighten the grinding