Florabest FLV 1200 A1 - Manual (Page 60)

60
GB
Wear can be identified from an increas-
ingly poor result.
The readjusting depth amounts to approx.
3 mm per setting.
When the implement is delivered it
is in the Transport Position 0 setting.
1. The implement must be switched off to
set the working position.
2. Pull the adjusting knob for adjustment
(see A 9) and turn it to the desired
position until it clicks into place.
Both wheels (right and left) must be in-
dividually set to the same position.
The setting button is not intended
for height adjustment but rather to
compensate for wear. Selection of
a readjustment position without the
corresponding wear can overload
the motor and damage the cylinder.
Switching on and off
Before switching on the im-
plement ensure that it is not
in contact with any objects.
Keep your feet and hands
well away from the cylinder
and the ejector opening. Dan-
ger of injury!
D 1. Place the implement on a level
lawn surface.
2. Connect the power cable (17)
with the extension cable.
3. Form a loop in the end of the
power cable and hang it into the
strain relief (18).
4. Connect the implement to the
mains voltage.
5. To switch on press the unlocking
button on the handle (1) and
simultaneously press the starting
lever (2). Release the unlocking
button (1).
6. To switch off release the starting
lever (2).
Overload protection: The mo-
tor is automatically switched off
when the implement is overloaded.
Release the starting lever and reset
the implement after a cooling down
period of approx. 1 minute.
WARNING! The cylinder con-
tinues to run for a brief pe-
riod after the implement has
been switched off. Do not tilt
or carry the implement while
the motor is still running and
do not touch the cylinder
while it is still rotating. Dan-
ger of injury!
Working with the implement
To maintain a well cared-for lawn it should
be aerated every 4 to 6 weeks.
Verticuting is a more intensive intervention
than aerating and should only be carried
out once a year, the best time being in
spring after the lawn has been mown for
the first time.
When working on slopes
always proceed across the
slope. Be particularly careful
when walking backwards
and pulling the implement.
Danger of stumbling!
After work and to transport the im-
plement disconnect the power plug
and wait until the cylinder is stand-
ing still.