Florabest FLV 1200 A1 - Manual (Page 57)

57
GB
turn the implement around or draw it
towards you. Danger of stumbling!
• Start or actuate the starting lever with
care and in conformity with the direc-
tions in these Instructions.
• Do not tilt the implement when start-
ing, other than it has to be lifted. In
this case tilt the implement only to the
extent that is absolutely necessary and
always lift the implement on the side
that is opposite to the operator.
• Never operate the implement without
the attached collection bag or impact
protector. Danger of injury! Always
keep well away from the ejector open-
ing.
• Do not operate the implement in the
vicinity of inflammable liquids or gases
as this could give rise to the danger of
a fire or explosion.
• Always disconnect the plug from the
mains socket before working.
Work intervals:
• After the implement has been turned
off, the cutting cylinder will continue to
rotate for a few seconds. Keep hands
and feet well away.
• Do not touch the spring tines before the
implement has been disconnected from
the mains and the spring tines have
come to a complete standstill. Risk of
injury owing to a sharp implement!
• Only remove plant parts when the
implement is standing completely still.
Ensure that the grass ejector opening is
clean and free.
• Switch off the power when the imple-
ment is to be transported, lifted or tilted
and when traversing other surfaces
than grass.
• Never leave the implement unattended
at the place of work. Children should
be supervised to ensure that they do
not play with the appliance.
• Always switch off the implement and
disconnect the power plug:-
- Whenever you leave the implement
- Before you clean the ejector open-
ing or unblock or unclog the imple-
ment
- When the implement is not being
used
- During all maintenance and clean-
ing work
- When the power cable is damaged
or has become tangled
- When the implement hits an obstruc-
tion during work or when unusual
vibrations arise. Establish the cause
and see if the implement has been
damaged. Do not repair it yourself!
Have the implement repaired by an
authorised workshop!
• Store the implement in a dry place
well out of reach of children.
CAUTION! The following states how
to avoid damage to the implement
and any resulting harm to people:
Take care of your implement:
• Switch off the power when the imple-
ment is to be carried across steps.
• Inspect the implement each time before
it is to be used. Never operate the im-
plement if safety devices (e.g. impact
protector, parts of the cutting facility
or bolts are missing, worn out or dam-
aged. Check especially the power
cable and starting lever for damage.
To avoid imbalance, all tools and bolts
must be exchanged as complete sets.
• Only use spare parts and accessories
that have been supplied or recom-
mended by the manufacturer. The use
of alien parts results in the immediate
loss of all guarantee claims.