Edirol SD-80 - Manual (Page 42)

42
Using the effects of the internal sound generator
Mod Rate (Modulation Rate) 0–127
Specifies the speed (frequency) at which the chorus sound will be modulated. Higher settings produce
faster modulation.
Mod Depth (Modulation Depth) 0–127
Specifies the depth of modulation for the chorus sound. Higher settings will produce deeper modulation.
Feedback 0–127
Specifies the level of the chorus sound that will be re-input to the chorus (i.e., the amount of feedback).
Feedback lets you produce a denser chorus sound. Increasing this value will raise the feedback level.
Send to Reverb 0–127
Specifies the amount of chorus sound that will be sent to reverb. Higher settings will increase the amount
that is sent to reverb.
■ EQ (Equalizer)
You can make equalizer settings for the output of the sound generator section.
EQ1L: EQ for the left channel (Lch) of the OUTPUT 1 stereo output
EQ1R: EQ for the right channel (Rch) of the OUTPUT 1 stereo output
EQ2L: EQ for the left channel (Lch) of the OUTPUT 2 stereo output
EQ2R: EQ for the right channel (Rch) of the OUTPUT 2 stereo output
EQ Switch Off, On
Switches the equalizer on/off.
EQ1 Low Frequency 200/400 Hz
EQ2 Low Frequency 200/400 Hz
Specify the frequency at which the low range will be adjusted.
EQ1 Low Gain -15–+15
EQ2 Low Gain -15–+15
Specify the gain (amount of boost or cut) of the low range. Increasing this setting in the positive direction
will emphasize the low range.
EQ1 High Frequency 2000/4000/8000 Hz
EQ2 High Frequency 2000/4000/8000 Hz
Specify the frequency at which the high range will be adjusted.
EQ1 High Gain -15–+15 dB
EQ2 High Gain -15–+15 dB
Specify the gain (amount of boost or cut) of the high range. Increasing this setting in the positive direction
will emphasize the high range.