Edirol SD-80 - Manual (Page 29)

29
Using the internal sound generator
Using the internal sound generator
■ Soloing a part
When multiple parts are sounding, you can cause only the currently selected part to sound, allowing you
to check the performance of that part. This is referred to as “
soloing ” the part.
fig.5-09
1. Press [INST] .
The button will light.
2. Press [PART ] or [PART ] to select the part that you want to solo.
fig.5-09a
3. Hold down [SHIFT] and press [PART ] to solo the part
you selected in step 2 . Parts other than the soloed part
will not sound, nor will the bar graph be displayed.
Solo will be defeated when you press [SHIFT] + [PART ] once again.
1,4 2
3