Extron electronic TP Receivers - Manual (Page 22)

TP Receivers • Installation and Operation
Installation and Operation, cont’d
2-10
All models except the TP R 15HD A can be mounted through a
table or podium using an Extron Through-Desk Mounting Kit
for 1/4 or 1/2 Rack Width Products (part #70-077-02). Furniture
mount the receiver as follows:
1
. Attach the mounting brackets to the receiver with the
machine screws provided (figure 2-5).
Extron
TP R BNC A
Extron
TP R BNC A
Extron
TP R 15HDA
RGB IN
PUT
RGB OUTPUT
R
G
B
H/H V
V
A
AUDI O
L
R
B
SO G C SYNC
PO WE R
15V . 5A DC
L R
RG B I NP UT
RG B O UT PU T
R
G
B
H/H V
V
A AU DIO
L
R
B
SOG C SY NC
PO WE R 15V .5 A D C
L R
Through-desk
Mounted
Under-desk
Mounted
Under-desk
Mounted
TP R 15HD
A
RGB
PEA
KIN G
LEV EL
Figure 2-5 — Under-desk or through-desk mounting
2 . For through-surface mounting (all except TP R 15HD A) ,
cut the proper sized hole in the mounting surface.
3 . Hold the receiver with the attached brackets against the
underside of the table or other furniture. Mark the location
of the screw holes of the bracket on the mounting surface.
4 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
5 . For through-surface mounting (all except TP R 15HD A) ,
insert four #8 wood screws through the bracket and into
the four pilot holes. Tighten all four screws to secure the
receiver in place.
6 . For under-surface mounting , insert #8 wood screws into
the four pilot holes. Tighten each screw into the mounting
surface until slightly less than 1/4" of the screw protrudes.