Kcl-adapter kit-6b – Kichler 337005 User Manual
Page 7
Fig. 13
NOTE: The Hanger Ball can be installed
in ONLY one direction. The "cutout"
should be toward the "Lower" end of the
ceiling slope. (Fig. 13)
8. Now lift the motor assembly into position
with the hanger ball in the position (shown
in Fig. 13) and place the pivot pens on the
hanger ball into the pivot groves on the
hanger bracket. (Fig 13)
Next, lower the hanger ball until the pivot
pens rest in the bottom of the pivot groves.
(Fig 13)
9. Make sure the Safety Pen installed in
Fig 14 is installed but NOT tightened.
(Fig14)
DO NOT TIGHTEN AT THIS TIME
Hanger
bracket
6
SLOPE CEILING ADAPTER
Pivot groves
Pivot
pens
Fig. 14
Hanger
bracket
3/16” X 65 mm
Safety pin
See also other documents in the category Kichler Hardware:
- 12011 v.2 (1 page)
- 3000 (2 pages)
- 4100 (2 pages)
- 10566 (2 pages)
- 10579 (1 page)
- 10190BK60 (1 page)
- 10570 (1 page)
- 10215 (1 page)
- 12211 (1 page)
- 10198 (1 page)
- 10589 (1 page)
- 9592 (1 page)
- 12068 (4 pages)
- 12501 v.2 (1 page)
- 12353WH v.2 (1 page)
- 12382 (1 page)
- 12382 (2 pages)
- 12383 (1 page)
- 15070 (2 pages)
- 15215 (1 page)
- 4200 (1 page)
- 4900 (1 page)
- 4931 (2 pages)
- 4100 (2 pages)
- 15565 (1 page)
- 15529 (2 pages)
- 15635 (2 pages)
- 15509 (2 pages)
- 15578 (2 pages)
- 15777 (1 page)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15635 (2 pages)
- 15688 (2 pages)
- 15717 (2 pages)
- 15511 (1 page)
- 15620 (1 page)
- 15415 (2 pages)
- 15671 (1 page)