Rough-in t e mplates, Rough-in t emplates, cont’d – Extron Electronics RGB 500_Dual User Manual
Page 18
RGB 500 Series • Rough-in Templates
RGB 500 Series • Rough-in Templates
Rough-in T
emplates, cont’d
B-3
RGB 500 Dual, RGB 508, RGB 560 Dual and RGB 568
Rough-in Template
Use this template as a guide for cutting the hole in the installation surface (wall or
furniture) for the interfaces with a 4-gang size faceplate. This diagram is actual
size.
This light gray area represents where the
interface enclosure (2.50” H x 3.70” W) will be
located against the rear of the RGB 500 Dual,
RGB 508, RGB 560 Dual or RGB 568 front panel.
The dashed line indicates the recommended
cut-out area (3.875” H x 7.525” W)
for the installation surface.
This light gray area represents where the
second interface enclosure (2.50” H x 3.70” W)
will be located against the rear of the
RGB 500 Dual or RGB 560 Dual front panel.
The solid, outer line (4.50” H x8.325” W)
represents the outside edge
of the wall mounting bracket.
Rough-in T
e
mplates
RGB 500 and RGB 560 Rough-in T
emplate
Use this template as a guide for cutting the hole in the
installation surface (wall or furniture). This diagram is for the
interfaces with 2-gang size faceplates. It is shown at actual size.
The dotted line indicates the recommended
cut-out area (3.875
” H x 3.80
” W)
for the installation surf
ace
.
The solid, outer line (4.50
” H x 4.60
” W)
represents the outside edge
of the w
all mounting br
ac
k
et.
T
emplate f
or the 2-gang
mounting brac
ket
B-2