Preliminary – Extron electronic Multi-Graphic Processor MGP 464 DI User Manual
Page 77
4-25
MGP 464 • Softwar
e Configuration and Contr
ol
PRELIMINARY
Command/response table for IP SIS commands (continued)
Command
ASCII (Telnet)
(host to processor)
URL Encoded (Web)
(host to processor)
Response
(Processor to host)
Additional description
Bi-directional serial data port (continued)
Configure mode
24
E
X!
*
X2(
CY
}
W
X!
%2A
X2(
CY
|
Cpn
X!
• Cty
X2(
]
Select serial mode
X2(
for port
X!
.
X!
= 01 through 99.
For
X2(
:
0 = RS-232
1 = RS-422
N
Only the rear panel RS-232/422 port
can be configured. Therefore,
X!
= 1.
View mode
E
X!
CP
}
W
X!
CY
|
X2(
]
Configure flow control
24
E
X!
*
X3)
,
X3!
CF
}
W
X!
%02A
X3)
%02C
X3!
CF
|
Cpn
X!
• Cfl
X3)
,
X3!
]
Set flow control type
X3)
with
X3!
ms
between bytes. For
X3)
:
H = Hardware.
S = Software.
N = None (default).
X3!
= 0000 through 0001; default = 0 ms.
View flow control
E X!
CF
}
W
X!
CF
|
X3)
,
X3!
]
Configure receive timeout
24
E X!
*
X1&
*
X2)
*
X2#
*
X2!
CE
}
Set the time that the MGP will wait for a
response before terminating the command.
W
X!
%2A
X1&
%2A
X2)
%2A
X2#
%2A
X2!
CE
|
Cpn
X!
• Cce
X1&
,
X2)
,
X2#
,
X2!
CE
]
N
X1&
= Time in tens of milliseconds that the MGP will wait until receipt of the first response character before terminating the command. (Default = 10 = 10 ms; max. = 32767.)
X2)
= Time in tens of milliseconds that the MGP will wait between characters being received via a serial port before terminating the current command or receive operation.
(Default = 20 = 20 ms; max. = 32767.)
X2!
= #L or #D. The letter parameter is case sensitive (requires capital D or capital L). For
X2!
:
L = Length of the message to be received,
D = Delimiter value. A delimiter of ASCII 0A = 10D.
# = Byte count (for L) or a single ASCII character expressed in decimal form (for D).
Byte count # can be 0 through 32767; default = 0. The ASCII decimal # can be 0 through 00255; default = the byte count. A 3-byte length = 3L.
The response includes leading zeros.
X2#
= Priority Status for port
X!
receiving timeouts. For
X2#
:
0 = Use Send data string command parameters (default); 1 = Use Configure receive timeout command parameters. The response includes leading zeros.
View receive timeout
E X!
CE
}
W
X!
CE
|
X1&
,
X2)
,
X2#
,
X2!
]