Connecting to a power source, Connecting to the console port, Figure 3-8 – Enterasys Networks V2H124-24P User Manual
Page 42: Power receptacle, Figure 3-9, Serial port (db-9 dte) pin-out
Installing the Switch
3-8
3
Connecting to a Power Source
To connect a switch to a power source:
1.
Insert the power cable plug directly into the AC receptacle located at the back
of the switch.
Figure 3-8. Power Receptacle
2.
Plug the other end of the cable into a grounded, 3-pin socket, AC power source.
Note: For international use, you may need to change the AC line cord. You must use a
line cord set that has been approved for the receptacle type in your country.
3.
Check the front-panel LEDs as the device is powered on to be sure the PWR
LED is lit. If not, check that the power cable is correctly plugged in.
Connecting to the Console Port
The DB-9 serial port on the switch’s front panel is used to connect to the switch for
out-of-band console configuration. The command-line configuration program can be
accessed from a terminal or a PC running a terminal emulation program. The pin
assignments used to connect to the serial port are provided in the following table.
Figure 3-9. Serial Port (DB-9 DTE) Pin-Out
100-240V~ 50-60Hz 7.5A
Power Socket
1
5
6
9