Enterasys Networks V2H124-24P - Manual (Page 24)

Introduction
1-4
1
The port status LEDs have two display modes: Link and PoE. The Link mode
displays the link status and network activity on each port. The PoE mode displays
the PoE power status on each port. Use the Mode Link/PoE button (see "Mode PoE/
Link Button" on page 1-6) on the front panel to toggle between the two display
modes. The current mode is indicated by the Link/Act and PoE system LEDs.
Table 1-1. Port Status LEDs
Figure 1-3. System LEDs
LED Condition Status
1~24
(Link/Act Mode) On/Flashing Green Port has established a valid 100 Mbps network connection.
Flashing indicates activity.
On/Flashing Amber Port has established a valid 10 Mbps network connection.
Flashing indicates activity.
Alternate Green/Amber Port has been disabled by the administrator.
Off
There is no valid link on the port.
1~24
(PoE Mode) On Green Powered device is connected, but not drawing power.
Flashing Green Powered device is receiving power.
Flashing Amber Port has detected a power overload or short circuit and shut
down the port’s power.
On Amber The power budget for the switch has been exceeded and
the port's power shut down.
Alternate Green/Amber Port has been disabled by the administrator.
Off
No powered device is connected to the port.
Link/Act
PoE
25
26
PWR
Diag
Stacking
Mode
PoE/Link
System Status LEDs