Eagle Electronics CUDA 350 S/MAP User Manual

Page 27

Align plastic ratchets in bracket.

2. Aligning the transducer on the transom. Slide the transducer

between the two ratchets. Temporarily slide the bolt though the

transducer assembly and hold it against the transom. Looking at the

transducer from the side, check to see if it will adjust so that its face

is parallel to the ground. If it does, then the "A" position is correct for

your hull.
If the transducer's face isn't parallel with the ground, remove the

transducer and ratchets from the bracket. Place the ratchets into the

holes in the bracket with the letter "B" aligned with the dot stamped

in the bracket.
Reassemble the transducer and bracket and place them against the

transom. Again, check to see if you can move the transducer so it's

parallel with the ground. If you can, then go to step 3. If it doesn't,

repeat step 2, but use a different alignment letter until you can place

the transducer on the transom correctly.

Dot