Eclipse - Fujitsu Ten CD5425E - Manual (Page 57)

If you have a question:
„ 121 „
If you have a question:
First check the item mentioned below before attempting to troubleshoot problems.
The information listed in the chart below is displayed to show the status of the CD and CD changer.
Refer to the chart for the appropriate action.
[RESET] button
CAUTION
If a problem occurs, for instance when the unit does not respond to any button presses, or the
display doesn't work correctly, press the [RESET] button using a paper clip or similar item.
Pressing the [RESET] button will delete all the entries from memory. The settings will return to
those made at the factory prior to shipment.
Displayed information (for troubleshooting)
Information Contents Explanation and remedial action to take
INFO 2 NO DISC LOADED IN THE
MAGAZINE There is no disc in the magazine or player. Load
a disc in the magazine. (Load a music disc.)
INFO 3 DISCS ARE DIRTY OR
DAMAGED The loaded disc is dirty or upside down. Check it
for proper orientation and verify it is clean.
INFO 5 CD PLAYER AND CD
CHANGER FAILS
MECHANICALLY • The CD player and CD changer is inoperative
for some reason. Go through the magazine
removal procedure.
• If a magazine fails to eject, have your dealer fix
problem.
INFO 6 WHEN THE CD PLAYER
AND CD CHANGER
INTERNAL TEMPERATURE
IS HIGH (TO PROTECT
PICKUP UNIT) • The temperature in the CD player and CD
changer is too high for operation. Wait till it
cools down.
• Resume playing after the "High temperature
sensed and CD stopped" display disappears. If
the CD still cannot play, have your dealer
repair it.
INFO 7 AN INTERNAL POWER
SUPPLY FAILURE IS
OCCURRING • Turn the ACC off once before turning it on
once again to resume the operation.
• If this condition persists, please contact your
dealer.
LOAD CD changer is in the process of verifying the
presence of CDs after a magazine has been
inserted into the CD changer.
XV
XVI