Eclipse - Fujitsu Ten CD5425E - Manual (Page 43)

How to operate the AUDIO CONTROL
„ 107 „
How to operate the AUDIO CONTROL
Various audio control modes may be fine-tuned using this procedure.
Modes will switch in the order shown below each time the button is pressed.
VOL ➔ BASS ➔ MID ➔ TREB ➔ BAL ➔ FAD ➔ NON-F* 1 ➔ SVC* 2 ➔ LOUD
➔ VOL www
*1: NON-F (non-fader) Output is not affected by the settings of the BASS, MID,
TREBLE, loudness function or equalizer.
*2: Setting cannot be made in FM mode.
ATTENTION
Press the [MUTE] button for less than one second to cut the volume or restore it instantly.
Switching audio control modes
1
Press the [AUDIO CONTROL] button for less than one second to select the item
to be adjusted.
WARNING
Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a
safe location.
Mode Function
[AUDIO CONTROL] button
Turn to the Right Turn to the Left
VOL (VOLUME) Adjusts volume. Increases the volume.
Decreases the
volume.
BASS
AAdjusts bass level. Bass mode can be
adjusted for each source
(CDP/CDC, FM ,AM(MW) and LW).
Emphasizes low
sounds.
Softens low sounds.
MID (MIDDLE)
Adjusts middle level. Mid mode can be
adjusted for each source
(CDP/CDC, FM , AM(MW) and LW).
Emphasizes medium
sounds. Softens medium
sounds.
TREB (TREBLE)
Adjusts treble level. Treble mode can be
adjusted for each source
(CDP/CDC, FM , AM(MW) and LW).
Emphasizes high
sounds.
Softens high sounds.
BAL (BALANCE) Adjusts left/right speaker balance.
Emphasizes right
speakers. Emphasizes left
speakers.
FAD (FADER) Adjusts front/rear speaker balance.
Emphasizes front
speakers. Emphasizes rear
speakers.
NON-F (NON-FADER)
Adjusts non-fader level (for connected
sub-woofers, etc.).
Increases level. Decreases level.
IX
X