beautypg.com

For your safety read before lighting, Lighting instructions, Intermittent pilot lighting instructions – Empire Comfort Systems DVP42FP7 EN User Manual

Page 35

background image

Page 35

17375-6-0705

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

A. This appliance is equipped with an ignition device which

automatically lights the pilot. Do not try to light the pilot

by hand.

B. BEFORE LIGHTING smell all around the appliance

area for gas. Be sure to smell next to the floor because some

gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

• Do not try to light any appliance.

• Do not touch any electrical switch;

do not use any phone in your building.

• Immediately call your gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire

department.

C. Use only your hand to push in or turn the gas control

knob. Never use tools. If the knob will not push in or

turn by hand, don't try to repair it; call a qualified

service technician. Force or attempted repair may

result in a fire or explosion.

D. Do not use this appliance if any part has been under

water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of

the control system and any gas control which has

been under water.

LIGHTING INSTRUCTIONS

1. STOP! Read the safety information above.

2. Set the thermostat to lowest setting.
3. Turn off all electric power to the appliance.
4. This appliance is equipped with an ignition device

which automatically lights the pilot. Do not try to light

the pilot by hand.

5. Lower louver front assembly.

6. Turn gas control knob clockwise

to

"OFF."

7. Wait ten (10) minutes to clear out any gas. Then

smell for gas, including near the floor. If you smell gas,

STOP! Follow "B" in the safety information above. If

you don't smell gas, go to the next step.

8. Turn gas control knob counterclockwise

to "ON".

9. Close louver front assembly.
10. Turn on all electric power to the appliance.
11. Set thermostat to desired setting.
12. If the appliance will not operate, follow the instructions

"TO TURN OFF GAS TO APPLIANCE" and call

your service technician or gas supplier.

TO TURN OFF GAS TO APPLIANCE

INTERMITTENT PILOT LIGHTING INSTRUCTIONS

GAS CONTROL KNOB

SHOWN IN "OFF” POSITION.

ON

HONEYWELL

OFF

1. Set the thermostat to lowest setting. (if applicable.)

2. Turn off all electric power to the appliance if service is to be

performed.

3. Open bottom louver assembly.

4. Turn gas control knob clockwise

to "OFF". Do not

force.

5. Close bottom louver assembly.

This manual is related to the following products: